(1)First
line is used for headings. Do not make any
changes to this line.
|
(2)This
is where you enter the tone number(this
is the value minus 1 from the number of Program
Change). Do not make any changes to this
column. |
(3)This
is where you enter the name of the tone. Do not
make any changes to this column.
|
(4)This
is where you set the value for Volume as a
definite value.
|
(5)You
can specify the value for Volume by using
"%" and "+-". If you specify
"100%", the original value will be
used.
|
(6)This
is where you set the value for Velocity as a
definite value.
|
(7)You
can specify the value for Velocity by using
"%" and "+-". If you specify
"100%", the original value will be
used.
|
(8)This
is where you can adjust the tone by increasing
or decreasing single octave. If you specify
"0", the original tone will be used.
If you specify "+1", the tone will be
set to 1 octave up.
|
(9)This
is where you can replace tones. For example, if
you specify "10", the specified tone
will be replaced by the tone of music box.
|